This Cute Origami rabbit is made of single piece of square paper, there is no cutting required for creating this model. It is bit tricky but once you master it you can create lots of bunnies of different sizes.
Step 1:
Take the square of 8 by 8 inches.
Step 2:
Start by folding the paper in half horizontally.
Step 3:
Unfold the paper and now fold the bottom half portion to the center line.
Step 4:
Follow by folding the upper part to center line
Step 5:
Fold all the four corner to meet center line.
Step 6:
Now your paper will look like this.
Step 7:
Unfold the corners.
Step 8:
Open the folded corner and create triangle.
Step 9:
Create the triangles of four corners.
Step 10:
Fli the paper and hold it vertically. Now fold the top tip of the paper to center point as shown in above image. Repeat the same with bottom tip.
Step 11:
Flip the paper and fold it in half. Crease well
Step 12:
Unfold the paper.
Step 13:
Fold the paper on the dotted line.
Step 14:
Flip the paper.
Step 15:
Hold the narrow portion pointing upwards and fold the upper portion to backward and crease well.
Step 16:
Fold the paper horizontally in half.
Step 17:
Hold both the tip of the triangles and pull it in an upward direction, crease the fold well. This will be the head of the rabbit.
Step 18:
Fold the tip of nose to backward.
Step 19:
Unfold the nose and push the fold inside the paper model.
Step 20:
The model would look like this.
Step 21:
Fold the dotted line of the model to the backside.
Step 22:
Unfold the paper.
Step 23:
Open the paper and pinch the creases on the paper and fold the paper inside.
Step 24:
So model would look like this.
Step 25:
Fold the paper on dotted line.
Step 26:
Fold the edges inside.
Step 27:
At the end Put the fingers into the ear fold and puff it.
Origami Rabbit is ready…..
Side view of the Origami Rabbit
Back view of the Origami Rabbit
Front view of the Origami Rabbit
Top view of the Origami Rabbit 
